Lyngdorf Audio Portable Speaker W 210 User Manual

Owner´s manual

W210

Manual version 07-08-2007

Connecting

When connecting the W210s, always connect ”+” and ”-” from the ampliﬁer to the corresponding ”+”

and ”-” terminals on the W210 input.

Connect your speakers the same way to avoid phase errors.

Set-up of cut-off frequency

To match most speakers bass response, we recommend a cut-off frequency at 400Hz. But depending

on you speakers and room, the cut-off frequency can easily vary from 200-800Hz. Try experimenting to

get the best sound.

Level

Adjust the level of the W210s to match the sound level of your main speakers.

If applying RoomPerfect you can set the volume of the W210s a few dB to loud before making the

RoomPerfect calibration. RoomPerfect will then lower the bass to an appropriate level.

Cleaning

Please use a dust-free cloth to clean the speakers. It is also possible to use a slightly damp cloth for more

stubborn marks.

Under no circumstances should you use any kind of cleaning agent on, or in close proximity to, these

speakers.

Speciﬁcations

Product

W210

2 x 10”

Woofer/midrange driver

Frequency response

Sensitivity (2.83V/1m)

Nominal Impedance

16 - 3500 Hz

96dB

8 Ohm

Technical Assistance

For latest version of this document and ‘Questions and Answers’, please check the Lyngdorf Audio

website.

If you have any problems with or questions regarding your Lyngdorf Audio product, please contact

your nearest Lyngdorf Audio representative or:

Lyngdorf Audio ApS

Denmark

E-mail: info@lyngdorf.com